Some of these requirements can be regarding following points These needs to be reflected in isometrics drawings. Project Specific Instructions for Isometrics CheckingĮvery project has specific requirements.

Piping Isometric Drawing Checklist Isometric Drawing Symbols It includes General Isomtric Check Points as well as Project Specific Check Points. Isometric drawing needs to be checked as per project standard isometric drawing checklist. Inch Dia = Pipe size in Inch X Number of Joints Isometric Drawing Checklist Inch Meter = Pipe length in Meters X Pipe Size in Inch

Pipe line details such as Line Number, Line Size, Insulation, Tracing, Fluid Code, Operating and Design pressure and temperatures, Pressure Testing method such as hydrotest or pneumatic, Test pressure, Piping material class, Inch Dia etc.

Project details such as client name, engineering office name, project name, project number, process licensor etc.

Title bar section at the bottom consists of following information.

Whether shop material or field material.

It includes following information for all components : Section on left or right side of drawing consists of B ill of Material Section for the portion of line shown in isometric graphic. Main Graphic section consist of Isometric Representation of a pipe line route in 3D space, which includes following information : Piping isometric drawing consists of three sections. Piping fabrication work is based on isometric drawings. It is the most important deliverable of piping engineering department. With the 'Isometric to Standard' type transposition the result can often be visualized as an offset view from overhead, where the vertical lines can still be seen.Piping Isometric drawing is an isometric representation of single pipe line in a plant. This is to avoid any confusion caused by nodes being placed over the top of other nodes or pipes. When clicking the ISO Mode On/Off Toggle button to transpose from isometric view to a 'flattened' standard view, any vertical lines from the isometric view will be drawn at 45 degrees.

Selecting either of these options will change the display of all tanks and end pressure on the isometric view. The drawing menu provides options to display an ‘Isometric tank view from the left’ or to display an ‘Isometric tank view from the right’.

Tanks and end-pressure nodes will also be displayed in the isometric plane. When the isometric drawing mode has been selected Pipe Flow Expert will show fittings, valves, components, control valves and pumps in the isometric plane which follows the associated pipe direction. Users can easily switch between these using the ISO Mode On/Off Toggle button. Pipe Flow Expert has two drawing modes, standard (‘flattened’) view and isometric view.

Pipe isometric drawing